ROOF SAFETY ANCHOR BRACKET (ZINC PLATED) with BLACK WEATHER SEAL

ROOF SAFETY ANCHOR & SEAL

WHAT IS YOUR LIFE WORTH?

Safety is becoming more important and necessary in todays domestic and commercial building processes.

Our fixed single point fall-arrest Safety Anchor, designed for use on timber roof trusses/rafters, has been tested for static and dynamic load capacity in accordance with the new AS/NZS 5532-2013 STANDARDS.

For over 18 years Roof Extenda Pty Limited has been known for their second to none, superior products!

Four Installation Steps

• Remove roofing tiles or lift roof sheet to achieve an opening to fit the Roof

Extenda Safety Anchor Bracket.

• Bolt angle bracket section and flat plate sandwiching the selected rafter at approx. 300 mm from the roof's ridge with a minimum of 8 x M12 Hex Bolts, Nuts and Washers (Not supplied).

• Replace roof tiles or roof sheet, cutting a hole to allow the loop & rod to penetrate the roof.

• Slide Weather Seal over the loop and down the shaft. Ensuring roofing area is clean and dry, mark the position of the Weather Seal on the roofing. Apply clear neutral cure silicone to the area marked, press and shape the Weather Seal into the roof profile, finish with a bead of silicone to all edges of the Weather Seal to complete the fitting.