CHEMSET (RAMSET) 801 XTREM

CHEMSET 801 XC2 CARTRIDGE

Heavy Duty Epoxy Acrylate for anchoring threaded studs and reinforcing bar into solid concrete, stone, hollow brick and hollow concrete block. High bond strength for diamond and carbide drilled holes. Fast cure for high bond strength for diamond and carbide drilled holes. Fast cure for high productivity. Non- drip formula, ideal for over-head installation. Styrene free low order formula. Steel columns, and beams, starter bars, road stitching, seating, hand rails.

Features & Benefits:

• Excellent chemical resistance
• Suitable for use in contact with drinking water
• Strong bond

Specifications:

Properties
Typical Value
AppearancePart A: White part B: Black
Mixed: Dark Grey
Chemical Type
Epoxy
Density1.30kg / litre @ 20?CHeat Distortion temperature
Approx. 80?CHardness> Shore D 80
Compressive Strength (AS1012.9)
75MpaWater Absorption (ASTM D570)
< 0.2 % (10 days @ 25?C)Modulus Of Elasticity
> 4 GPa
Tensile Strength
> 25 Mpa
Flexural Strength
Approx. 22 MPa
Contact with drinking water AS/NZS4020
New CellService Temperature Limits
-10?C to 80?CWorking time (min) @ 20?C
6 to 10
Loading Time @ 20?C 14 hours
Min Installation Temp (?C) 5Max Installation Temp (?C) 40Min Service Temp (?C)-10Max Service Temp (?C) 80SubstratesSolid Concrete,Solid Stone (proof loading recommended),
Solid Brick

TradeApplication
ConcreterStarter Bars
Buliding ContractorThreaded Studs, Starter Bars
Civil ContractorStarter Bars Steel FabricatorThreaded Studs Balustrade ContractorThreaded Studs FormworkerStarter Bars
BricklayerStarter Bars
FitterThreaded StudsSeating Contractor
Threaded Studs

Installation in solid

• Drill or core hole to specified diameter and depth
• Remove dust and debris by brushing and blowing 3 times each (if hole is wet or flooded, remove excess water using wet / dry vacuum and allow to dry)
• Screw mixing nozzle onto cartridge and dispense 2-3 trigger pulls of adhesive to waste until colour is grey with no streaks
• Insert tip of Nozzle to bottom of the hole and dispense adhesive
• Fill hole to about 2/3 full
• Insert threaded stud or reinforcing bar with rotating motion to release trapped air
• Wait until adhesive has fully cured before loading
• Protect from water contact for 24 hours
• Clean up with acetone